tmdupre
Member
I have a 72" rotary cutter which currently has the shear pin pto shaft gearbox. My problem is when I put my pto on, majority of the time, it shears the shear pin. I'm using grade 2 half inch bolts from TS. So I've seen these shear pin to slip clutch adapters for sale. They are made to go on a round shaft gearbox to the round shaft end of the pto shaft. Here is one from Georgia equipment company. They sell them for $70.
Slip Clutch Pack, Shearpin to Slip Clutch Adapter
Anyone have any experience using this and if so, how has it worked for you? Will this hold up better? Any thoughts on what I could do to keep from shearing the shear bolts? Just looking for feedback from you who have used either one and what you liked about them. Thanks
Tom
Slip Clutch Pack, Shearpin to Slip Clutch Adapter
Anyone have any experience using this and if so, how has it worked for you? Will this hold up better? Any thoughts on what I could do to keep from shearing the shear bolts? Just looking for feedback from you who have used either one and what you liked about them. Thanks
Tom