dstig1
Elite Member
- Joined
- Apr 7, 2010
- Messages
- 4,798
- Location
- W Wisc
- Tractor
- Kubota L5240 HSTC, JD X738 Mower, (Kubota L3130 HST - sold)
I played around with the location of the SSQA plate earlier and that drove a lot of the decisions. I want to have it as far forward so the plow is closer to the tractor for one. Secondly, I now have it so the hoses come out just behind the plate. If i move it back any more, they will conflict. I could cut out a little of the plate, I suppose, though I really don't want to weaken the plate there.
And yes, the braces cannot move forward any more on the A frame. I also want them to hit the main frame to some degree for improved strength and stiffness. I don't want it sitting up on that pin bracket only.
So if the brace interferes with the cylinder, then my only option is to connect to the top of the A frame, in about the same location or just slightly back.
Need to do some more checking next...
And yes, the braces cannot move forward any more on the A frame. I also want them to hit the main frame to some degree for improved strength and stiffness. I don't want it sitting up on that pin bracket only.
So if the brace interferes with the cylinder, then my only option is to connect to the top of the A frame, in about the same location or just slightly back.
Need to do some more checking next...