sixwarden9
New member
I just built a grapple for my TC 40A with a 16LA loader. I am using one of my rear remotes to control the grapple. The cylinder is a 2"x6". I need to slow the grapple down to keep it from slamming open or closed.
I did a search for "flow restrictors" and came up with the following post: flow restrictor thread
This post left me quite confused. I would not like to spend an additional $50 dollars on adjustable valves as I am already past my budget. I was hoping to use the pinhole or restricted in one direction valves available at TSC or Northern Tool.
So the question is the same as in the post:
One or two flow restrictors and where do I put them?
I did a search for "flow restrictors" and came up with the following post: flow restrictor thread
This post left me quite confused. I would not like to spend an additional $50 dollars on adjustable valves as I am already past my budget. I was hoping to use the pinhole or restricted in one direction valves available at TSC or Northern Tool.
So the question is the same as in the post:
One or two flow restrictors and where do I put them?