OK I bought this very nice tractor, 520 hours on it. Now when I look at the pto lever to adjust it. I move the lever ahead and it flies ahead like it's spring loaded slams the front of the cover then there is now some play in the lever and I adjusted it for the .5" clearance. As found there was no clearance in the on position. Not sure if this will allow the pto to disengage, haven't tried it yet. The pto lever has been slamming the cover for a long time and has bent down the front edge of the lever slot on the cover panel. So is this normal for the lever to fly ahead when engaging? Is the clearance set after taking the slop out after moving to the on position. Do you have to remove the rear fender to take the cover plate off?
Advise
Thanks