Double 00 Soul
Silver Member
I have a B3030 with a 1271R tiller. The driveshaft for the tiller is a Wallenstein. The manual for the tiller shows a grease zerk in the middle of the shaft but there's no cutout in the middle of the plastic covering the shaft.
Does anyone know if there's a grease fitting in the middle of the shaft? Does anyone have a similar setup and if so, how do you get the plastic covering off to see if there's a grease fitting?
The dealer said he doesn't "think" there's a fitting there if there's no cutout on the plastic. That's not good enough, if there's a fitting there I want to grease it.
Thanks for any help you can give on this.
Does anyone know if there's a grease fitting in the middle of the shaft? Does anyone have a similar setup and if so, how do you get the plastic covering off to see if there's a grease fitting?
The dealer said he doesn't "think" there's a fitting there if there's no cutout on the plastic. That's not good enough, if there's a fitting there I want to grease it.
Thanks for any help you can give on this.