I just changed out the oil and transmission fluid in my Massey Ferguson GC2300. I used what was recommended in the manual.
When I tried to start it back up it coughed a bit and then stopped. Now, it will not really turn over. I have only done this about 3 times as I think that something is wrong. At first, I didn't have the bar that you have to disconnect to get to the engine reconnected. I have since reconnected it, hoping that there was a kill switch, but it still doesn't work.
I have triple checked to see that I used the proper fluids and I did. I have also double checked that all of the fittings and plugs are correct.
Does anyone have any suggestions on what I may be missing?
Thanks,
Whalen
When I tried to start it back up it coughed a bit and then stopped. Now, it will not really turn over. I have only done this about 3 times as I think that something is wrong. At first, I didn't have the bar that you have to disconnect to get to the engine reconnected. I have since reconnected it, hoping that there was a kill switch, but it still doesn't work.
I have triple checked to see that I used the proper fluids and I did. I have also double checked that all of the fittings and plugs are correct.
Does anyone have any suggestions on what I may be missing?
Thanks,
Whalen