HI All,
I recently purchased a 72inch king kutter tiller.
I have jd 4320 with imatch.
I have read a few post where people have altered the implement to fit the I match.
How is this done? Has anyone done it with a kk tiller? any photos?
I also purchased pats ez change because I knew the tiller would not fit the imatch, but now my problem with using PATS hitch is the pto shaft is to short, only 4 inch overlap when it should be 6.
I am thinking if I can get it to fit the imatch, I should be able to gain 2 inches on the shaft.
Any thoughts are greatly appreciated
JYD
4320
Wisconsin
I recently purchased a 72inch king kutter tiller.
I have jd 4320 with imatch.
I have read a few post where people have altered the implement to fit the I match.
How is this done? Has anyone done it with a kk tiller? any photos?
I also purchased pats ez change because I knew the tiller would not fit the imatch, but now my problem with using PATS hitch is the pto shaft is to short, only 4 inch overlap when it should be 6.
I am thinking if I can get it to fit the imatch, I should be able to gain 2 inches on the shaft.
Any thoughts are greatly appreciated
JYD
4320
Wisconsin