allen in texas
Platinum Member
- Joined
- Oct 26, 2007
- Messages
- 916
- Location
- Levelland, TX
- Tractor
- Kubota Grand L 5740, loaded R1's w/640 lbs cast weight, 854 loader
and I'm not sure how to do it.
The cylinder is what rolls my new ford two bottom plow over.
(hah, new to me, built in 1956 or so)
I cleaned out the cylinder and replaced the hoses and hooked it up and pulled the lever.
WHAM!!!!
It was violent!!!!! Turned over in about 1/2 a second. Scared the crap out of me.
Broke a piece of linkage.
I've heard of putting an orifice somewhere is the lines but I need to know how and where. Are fittings available that are already restricted. Is it just gonna make my tractor bypass. Does that hurt anything?
I would like this thing to take about 3 to 5 seconds to roll over and I can do that by feathering the controls but that's a pain in the patoot.
Suggestions???
Has anyone "actually" done this???
The cylinder is what rolls my new ford two bottom plow over.
(hah, new to me, built in 1956 or so)
I cleaned out the cylinder and replaced the hoses and hooked it up and pulled the lever.
WHAM!!!!
It was violent!!!!! Turned over in about 1/2 a second. Scared the crap out of me.
Broke a piece of linkage.
I've heard of putting an orifice somewhere is the lines but I need to know how and where. Are fittings available that are already restricted. Is it just gonna make my tractor bypass. Does that hurt anything?
I would like this thing to take about 3 to 5 seconds to roll over and I can do that by feathering the controls but that's a pain in the patoot.
Suggestions???
Has anyone "actually" done this???