RonMar said:I have a Leinbach 7200 ...
1. Put boom arch on lift arms and attach boom end to toplink attach point.
2. Back tractor so boom end is in corner of barn where gearbox/auger are
stood for storage. Lean gearbox away from wall where it stands and line
up pin and hole on end of boom to insert pin and lockpin.
3. Attach driveshaft to PTO and go start "makin hole".
...
I didn't even think of removing that pin for storage - brilliant! One note tho - also have the 7200 but I bought it for my L3130. I find that now with my 5030 and its cat-2 lift arms the auger doesn't lift quite high enough to clear the ground for travel. It doesn't take too long, but I do remove the auger before driving 'to work'.
Works like a champ tho!
-Brian