TJW
New member
Hello - New to the forum.
My 284LE overheats when I am brushcutting. I run it in 2nd gear. The main issue seems to be the radiator getting grass seeds plugged in it. Also the hood seems to keep the enging pretty hot. If I run it with the hood up in the early morning, it runs at about 100C. I think I need to pressure wash the radiator again to get the crud out. I use an air compressor, but it doesn't quite do it.
It seems this wasn't engineered very well. Has anyone figured out a good modification for this or a work around??
Thanks.
My 284LE overheats when I am brushcutting. I run it in 2nd gear. The main issue seems to be the radiator getting grass seeds plugged in it. Also the hood seems to keep the enging pretty hot. If I run it with the hood up in the early morning, it runs at about 100C. I think I need to pressure wash the radiator again to get the crud out. I use an air compressor, but it doesn't quite do it.
It seems this wasn't engineered very well. Has anyone figured out a good modification for this or a work around??
Thanks.