scratchpad
Bronze Member
Lonnnng story short.....just had the motor rebuilt with a new/used crank, new/used block, new bearings, seals, rings etc. Upon getting the tractor back, first time i start it up the low oil pressure light is solid lit at idle 900rpms and will start to blink away when raised to around 1000rpms. The light stays unlit at higher rpms but will start blinking and then solid when rpms drop down back into the 900 range. Upon one check i let the tractor sit at 14-1500rpms for a few minutes to see if the light will come on and the engine died. I started it back up and it idled rough between 700-900 so i shut it off. Changed out the fresh oil from rebuild, which came out like a water hose, and put in some fresh delo 400. I also changed out the oil pressure sending unit and still have the same issues.
Any help is appreciated.
Any help is appreciated.