kennyd
Advertiser
Oh,
Here are all that parts that make up the handle, the prices are NOT current though:
Here are all that parts that make up the handle, the prices are NOT current though:
The switches in the handle are only good for 1/10th of an amp, so the use of relays is required.
Oh,
Here are all that parts that make up the handle, the prices are NOT current though:
View attachment 729957
The new grip mounts with two bolts, so you'd have to at a minimum drill those holes. I am not sure if the diameter is the same either.Kenny - is this grip an easy replacement for the old knob? I have a 2007 3720 with the old knob. Would this grip screw be an easy swap (electronics aside)?
Are you asking me?Are you putting a harness on a switch that's already built into the pod, or adding your own switch? If adding your own, can you do either NO or NC momentary configuration?
Yep, sorry I wasn't clear. I think this might work for my application, perhaps even without the relay box. I'm thinking of using this as an alternate operator presence button, wired in parallel with a (assumed NO) seat safety switch, such that I can hold that button to lift my butt off the seat without the tractor shifting to neutral.Are you asking me?
We are adding a switch to the circuit board, it's explained on our website. The switches are NO, I'm not sure if a NC version is available.