Red Horse
Veteran Member
- Joined
- Dec 12, 2010
- Messages
- 1,174
- Location
- Bolton, MA
- Tractor
- Deere 655ZTrak, Deere 4720 Cab, 400 X LT 155
I'm looking at a 72" Land Pride Power Rake. to those familiar with these rakes, the "cutter ribs" on the roller are 3/4" square stock when new. This one is worn down to about 1/4" in height which says it is not going to move much material per rotation. I've never done any "hard facing" and am not sure I could do much with my Millermatic 230. So I'm thinking of buying some "round" stock or 1/2 x 1/2 square stock and welding that on-like a about a 1" bead every 4-6 inches both sides.
Anyone with experience doing this?
Thx
Anyone with experience doing this?
Thx