I blew the rod end seal on one of the lift cylinders on my 530B. It's a 2" cylinder with 1.25" rod. The rod end cap is a smooth cap with two blind holes that are parallel with the rod. It appreas that there must be a tool that needs to go into these holes to unscrew the cap. I have read other places to use a spanner wrench, but they must have different caps than I do becuase there are no notches to put the spanner wrench in. I tried to make a crude tool by welding a couple pins in a plate that fit over the rod and turning the cap off, but I just ended up bending the pins. Anyone got any advice on how to get this cap off? Are the threads left handed?
Thanks
Chris
Thanks
Chris