My 3pt would raise before w/o a load. I put a brush hog on yesterday, and it wouldn't lift it. It tried, but couldn't do it. I took the right side plate off to take a look as the MF dealer recommended. Didn't see anything wrong. I can see that my raise/lower lever actuates a mechanism in there. I pulled the stand pipe up out of the top cover, and didn't notice anything there either. I put it all back together and added oil to the full level, but now the thing won't raise at all. I can pick up the 3pt arms manually, but it doesn't even seem like there is any pressure there. I also started the engine and ran it with the cover open and didn't see anything wrong. Ran it with the stand pipe vent screw open, but no oil flowed out. It's like there is no pressure or flow anymore. What did I do to make it quit functioning all together, and what could cause it to not have enough pressure to lift when it has weight on it?