john m
New member
i think i put a picture on here, if not i`ll keep trying.
everything for this is made from steel i had on hand. all the arms and tower uprights were a big steel table i had. there was a 4' x 6' 1/8 diamond plate steel sheet for the top which i used for the bucket. i got 4 sides out of it and the guy who gave me the table gave me a 1/4 piece for the top of the bucket. the cylinders i got from northern tool along with the pump. the valve came off of a 318 john deere i bought off of ebay. the tiller came with the tractor. i designed the loader so i can run the tiller at the same time. the tiller runs off the front pto like normal but the pump runs off of a stock pulley that the drive shaft links to.
everything for this is made from steel i had on hand. all the arms and tower uprights were a big steel table i had. there was a 4' x 6' 1/8 diamond plate steel sheet for the top which i used for the bucket. i got 4 sides out of it and the guy who gave me the table gave me a 1/4 piece for the top of the bucket. the cylinders i got from northern tool along with the pump. the valve came off of a 318 john deere i bought off of ebay. the tiller came with the tractor. i designed the loader so i can run the tiller at the same time. the tiller runs off the front pto like normal but the pump runs off of a stock pulley that the drive shaft links to.