I think understand what it does, at least in theory, but my manual makes no mention on how to use it. From what I understand you can adjust it to a desired draft or load when pulling a plow and if the draft gets above or below your setting it will automatically raise or lower the plow to maintain a constant draft.
I have a position control lever that raises the 3pt up and down and a draft control lever that is marked 1 on one end and 10 on the other. I can move the draft lever every which way and I notice nothing happening. How do I set it?
I have a position control lever that raises the 3pt up and down and a draft control lever that is marked 1 on one end and 10 on the other. I can move the draft lever every which way and I notice nothing happening. How do I set it?