firel7
New member
I have a Kubota B7500 and i Just had to replace an Upper 3 point hitch arm. While doing this repair I had to remove the Upper portion of the valve block. I was able to keep the valve attached to the block and replace as it was previous( as far as I could tell anyways). well now when operating the tractor I have noticed a restricted flow sound when the valve lever is in the float position? If I move the lever just slightly rearward the sound stops. There is no flow problems as far as I can tell when in the hold position or when raising. The flow is restricted enough that I can actually feel it in the power steering. I was wondering if anyone had a possible obvious solution?
The tractor has 500 hours on it and I just changed the hydraulic fluid at 400 hrs so I would not think that to be a problem however I guess I couldn't rule out th possibility of debris entering following or during the repair however I think it is probably unlikely and would prefer to look at other avenues first. I would hate to try changing fluid only to find that that is not the problem ( I really tend to doubt it is) and then have to open it up and do it again.
Any suggustions would be greatly appreciated.
The tractor has 500 hours on it and I just changed the hydraulic fluid at 400 hrs so I would not think that to be a problem however I guess I couldn't rule out th possibility of debris entering following or during the repair however I think it is probably unlikely and would prefer to look at other avenues first. I would hate to try changing fluid only to find that that is not the problem ( I really tend to doubt it is) and then have to open it up and do it again.
Any suggustions would be greatly appreciated.