Dnhluch
New member
- Joined
- Aug 12, 2015
- Messages
- 4
- Location
- Ravenna ohio
- Tractor
- New Holland workmaster 65,Case 301, termite t5c
Have WM 65 2011 sitting with not starting have 392 hours . So far had shift neutral switch go bad( shorted around it) seat switch routed over rail went open( spliced), starter solenoid wire routed over exhausted ground out fuse blown( re routed and taped burnt wire replaced fuse).
Now trying to get wiring diagram from dealer looking for open to fuel solenoid. Did start for minute when key left on for 10 minutes. I started with dealer service department who gave me parts department who went to service looking for wiring schematic- no luck into response in two days.third day went service department and they reluctantly supplied SD & CD for WM55 which looks pretty close to my WM65. Will see I figure out my problem later today.
Now trying to get wiring diagram from dealer looking for open to fuel solenoid. Did start for minute when key left on for 10 minutes. I started with dealer service department who gave me parts department who went to service looking for wiring schematic- no luck into response in two days.third day went service department and they reluctantly supplied SD & CD for WM55 which looks pretty close to my WM65. Will see I figure out my problem later today.
Last edited: