DiskDoctr
Platinum Member
I've searched but can't find this info. I am looking for a diagram of the Nimco joystick valve used on the FEL of my 2004 3510 (Shuttle shift).
I have read it has an adjustable relief and it already has the PB plumbed to the included rear remote.
I want to check then adjust the relief, and add to the rear remote for TnT. I have the hydraulic toplink from CCM some years back and would like to add tilt.
If there is a post on how to adjust the relief (where/how), I didn't find it.
I may add a hydraulic angle for a back blade and york rake in the near future. Maybe go with a 3 position selector off the existing remotes and use the in-built lever for controlling? I can live with adjusting one at a time.
Thanks!
- JC
I have read it has an adjustable relief and it already has the PB plumbed to the included rear remote.
I want to check then adjust the relief, and add to the rear remote for TnT. I have the hydraulic toplink from CCM some years back and would like to add tilt.
If there is a post on how to adjust the relief (where/how), I didn't find it.
I may add a hydraulic angle for a back blade and york rake in the near future. Maybe go with a 3 position selector off the existing remotes and use the in-built lever for controlling? I can live with adjusting one at a time.
Thanks!
- JC