budepps3760
Silver Member
I have a Mahindra 2810 and I am working on installing top and tilt on it. There are currently no hydraulics except for the 3PH. I removed my seat and identified what I believe for certain 1 of the ports and possibly the second.
The first picture shows what I believe to certaintly be a port. It is horizontal in orientation and has a small threaded plug installed.
The second picture shows what I believe to be a second port. Whereas the first port was horizontal and fairly small, the second picture shows this potential port to be larger in diameter and vertical in orientation. As I examined this second tube/port it definitely has a threaded cap on it.
These are the only 2 possible ports that I could find in this area. Based on the different diameters of the 2 ports, which would be the outflow from the tractor to the control levers, and which would be the return flow from the control levers back to the hydraulic fluid reservoir on the tractor?
I am working with fitrighthydraulics, a company that comes highly recommended by the folks on this forum. I appreciate any help that you could provide.
The first picture shows what I believe to certaintly be a port. It is horizontal in orientation and has a small threaded plug installed.
The second picture shows what I believe to be a second port. Whereas the first port was horizontal and fairly small, the second picture shows this potential port to be larger in diameter and vertical in orientation. As I examined this second tube/port it definitely has a threaded cap on it.
These are the only 2 possible ports that I could find in this area. Based on the different diameters of the 2 ports, which would be the outflow from the tractor to the control levers, and which would be the return flow from the control levers back to the hydraulic fluid reservoir on the tractor?
I am working with fitrighthydraulics, a company that comes highly recommended by the folks on this forum. I appreciate any help that you could provide.