hwp
Platinum Member
I have a Kubota F2400 with a three blade RC60 mower deck. What is the best way of sharpening and balancing the mower blades. In the past I sharpened them using a bench grinder but lately I have been using an angle grinder. Is one way better than the other? Or are there even better ways? I have read somewhere that the blades should have a flattened surface of 1/64" on the leading edge. How do you do this?
I check the balance of the blades by putting them on a bolt and spinning them by hand in the vertical plane? Should they be checked in the vertical or horizontal plane? Should the check be static or dynamic?
I check the balance of the blades by putting them on a bolt and spinning them by hand in the vertical plane? Should they be checked in the vertical or horizontal plane? Should the check be static or dynamic?