Mtngrancher
New member
Need some advice from the snowblower users. I would like to replace my steel edge with something else to protect some patterned concrete on my property. I have the SB240, and it does a terrific job. I never use my 84" plow because the blower is so fast and precludes the need of ever doing push backs. I have about 800' of drive I've been blowing. 80' of it near the house and barn is patterned concrete, which has some funky angles in it to channel water into a dry creek that separate the barn and house. The sharp edge of the blower blade has made a few gouges in the concrete early on. I've been leaving an inch or two of snow in the meantime.
I've looked at the poly and rubber plow edges that are common on plows for the blower, but the thickness will require me to have only bolts holding the edge to the machine, if it fits at all. Has anyone made this mod?
I've seen Rip's post on the round bar, which seems like a good alternative if I can't make the softer edges work.
Cheers and Happy New Year, Mtngrancher
I've looked at the poly and rubber plow edges that are common on plows for the blower, but the thickness will require me to have only bolts holding the edge to the machine, if it fits at all. Has anyone made this mod?
I've seen Rip's post on the round bar, which seems like a good alternative if I can't make the softer edges work.
Cheers and Happy New Year, Mtngrancher