Arkinsaw Dave
Member
Had my new tractor delivered yesterday and went to hook up the bush hog. The left pin came out just by using my fingers, but the right one took a bit of hammer work from the bottom side and then a lot of pulling and wiggling from the topside with pliers. Putting it back in required a hammer as well. I got to looking and the holes on that side just dont seem to match up very well. Has anyone ran into this and is running a drill through each of the holes a good idea? thanks for the help / advice.
ps I thought maybe it was just a new thing, but when I went to unhook the mower it was the same deal, cant get the pin in any of the holes on that side easily, they go through with a little hammer persuasion though.
ps I thought maybe it was just a new thing, but when I went to unhook the mower it was the same deal, cant get the pin in any of the holes on that side easily, they go through with a little hammer persuasion though.