Ridgewalker
Platinum Member
My Brush-hog isn't parallel with the back of my tractor and I can't figure out
what I am doing wrong. I can get it to line up but once I start cutting it
ends up running outside my right wheel on an angle.
I'm not sure if I have the hookups on correctly and would appreciate any schooling I can get.
See attached.
Thanks in advance!
what I am doing wrong. I can get it to line up but once I start cutting it
ends up running outside my right wheel on an angle.
I'm not sure if I have the hookups on correctly and would appreciate any schooling I can get.
See attached.
Thanks in advance!