I have a JX95 and my temperature gauge is not functioning. I have power at the sending unit and I have power at the gauge. I tried plugging in a new dash cluster and the gauge did not work on it either. I then put a new sending unit on the plug and put it in water that was at least 180 deg. and it still did not work. I then plugged the new cluster in with the new sending unit and that still did not work. At the back of the gauge there are 3 terminals or studs in a triangular pattern. The center one is ground one side is full voltage and the other is the sending voltage and I have current on both sides. Does anyone have a clue.:confused2: