Timing a NH 565 Baler

   / Timing a NH 565 Baler #1  
F

flyfisher123

New member
Joined
Jun 6, 2017
Messages
3
Location
Peterborough, NH
Tractor
Toro Groundsmaster 325d
Can any farmers help?
Broke the pickup drive belt last year on my 565 baler.....discovered the knotter clutch was messed up when I went to replace the belt... FINALY got new clutch...installed it today...can anyone give me step by step instructions on checking and retiming... or better yet upload relevant pages from a manual? (Hay window coming...would love to know baler is 100% before cutting....)
 
   / Timing a NH 565 Baler #2  
Baler timing should be outlined in 565 operators manual. I can't help on timing NH baler as I've always owned a JD small sq baler & I could time those in my sleep.
 
   / Timing a NH 565 Baler #3  
   / Timing a NH 565 Baler #4  
I just had a thought post your 565 timing question on Haytalk.com. I'll bet Mike10 or some other member can tell you how to time it.
 
   / Timing a NH 565 Baler #5  
I don’t have pictures but there is 3 dots on each piece make sure they are lined up. And there is 2 lines that the plunger should be centered between
 
   / Timing a NH 565 Baler #6  
dan28040 said:
I don’t have pictures but there is 3 dots on each piece make sure they are lined up. And there is 2 lines that the plunger should be centered between
Click to expand...

Where you pull the gears apart to put the belt on. Is where your dots are.
 
   / Timing a NH 565 Baler #7  
10 degrees before top dead center should be good. measured at full RPM.
 
   / Timing a NH 565 Baler #8  
radios1 said:
10 degrees before top dead center should be good. measured at full RPM.
Click to expand...

I never heard degrees utilized in small sq baler timing nor would I know how that could be performed. I've been repairing small sq balers since the late 1960's.
 
You must log in or register to reply here.
 

Footer Links 1

Top