I have a 2013 5600F.With seat all the way back you have about 1/2 to 3/4 inch before you hit the back that is all no more.The distance from bulge in seat back to bottom part of dash is 31 1/2 inches. From the deepest part of seat to overhead you have about 39 1/2 inches. If you went up vertical you could go back also. That would be no trouble at all. Just make some riser bars for under seat rail.They are a good machine overall but it has it's limits as all equipment does. On side slope machine can be very dangerous if it is slick mud or even slippery leaves. The four wheel drive leaves a little to be desired. Not to scare you but keep that in mind. Going straight up hills I have 45 degree + hills and it has no trouble at all. Good luck....For all you tall (over 6'1" plus) Toolcat D-model vets, how well do your legs fit? I'm considering a purchase, am 6'2" (a more legs then torso 6'2") and have found the machine cramped when sitting in the driver's position. Very disappointing given the size of the machine compared to smaller UTV's that are predictably lousy on legroom. Is there any room behind or below the seat for modification? I would probably need 2-3 more inches. Think that's possible? Thanks and great forum!
Last edited: