OP
jpsheldrake
New member
- Joined
- May 28, 2011
- Messages
- 6
- Tractor
- Jimna 284
Hello Again.
Sorry for not responding sooner but have been away for a few days!!
Back to the tractor, as I am a novice just wanted to check the attached photo is the right area. When I move the f/r level the circle in the middle does not move so I assume the new roll pins (once I locate) go in the circle (as per picture).
Sorry but I just want to make sure as I can't see any parts of the old roll pin and not sure if they are still inside the shaft or not!!
Thanks again,
Justin
Sorry for not responding sooner but have been away for a few days!!
Back to the tractor, as I am a novice just wanted to check the attached photo is the right area. When I move the f/r level the circle in the middle does not move so I assume the new roll pins (once I locate) go in the circle (as per picture).
Sorry but I just want to make sure as I can't see any parts of the old roll pin and not sure if they are still inside the shaft or not!!
Thanks again,
Justin