GBHRPS
Bronze Member
I've had my used Z-Force 48 for two months now and have always found it to be very busy to steer. I'm constantly forced to make steering corrections in order to make the unit mow in a straight line, and on my bumpy property the task is very arm tiring.
It came time this week to check fluids, and grease all of the fittings. While doing the front bogey wheels I discovered that the wheel bearings had been neglected by the previous owner. They flopped side to side inside the supports for the wheel axles, so much so that the side of one tire had rub marks from rubbing up against the wheel support.
After replacing the bearings in both bogey wheels and lubing them up properly, I was amazed at the transformation in the steering of the unit. It tracks so much better and much less steering input is necessary to aim the unit where it needs to go.
If you have a lot of hours on your zero turn, check the slop and lubrication of your front bogey wheel bearings, and replace the bad parts if necessary. Your mower will be so much easier to use if you do.
It came time this week to check fluids, and grease all of the fittings. While doing the front bogey wheels I discovered that the wheel bearings had been neglected by the previous owner. They flopped side to side inside the supports for the wheel axles, so much so that the side of one tire had rub marks from rubbing up against the wheel support.
After replacing the bearings in both bogey wheels and lubing them up properly, I was amazed at the transformation in the steering of the unit. It tracks so much better and much less steering input is necessary to aim the unit where it needs to go.
If you have a lot of hours on your zero turn, check the slop and lubrication of your front bogey wheel bearings, and replace the bad parts if necessary. Your mower will be so much easier to use if you do.