I bought a 97 1235 with 91 hours on it two years ago when I bought my property. I've used the heck out of it with little to no issues until late this summer, now at 250ish hours. The HST seems to...

Noticed my mid PTO was leaking fluid. Found the 2 bolts securing the cover plate were loose so I tightened them but leak persisted. Removed cover plate and saw that there was not gasket or seal...

We would like to extend a very hardy THANK YOU to all who made suggestions on how to repair our Massey Ferguson 1235. After some ado with a hydraulic shop, we finally have a line to properly fit...

ello and thank you for allowing me to join your group. I am looking for some help locating a power steering part for a Massey Ferguson 1235 series. O.E.M. number is 3607333M91 , this is a steel...

Hello and thank you for allowing me to join your group. I am looking for some help locating a power steering part for a Massey Ferguson 1235 series. O.E.M. number is 3607333M91 , this is a steel...

Hello and thank you for allowing me to join your group. I am looking for some help locating a power steering part for a Massey Ferguson 1235 series. O.E.M. number is 3607333M91 , this is a steel...

Hello everyone. 2 years ago, I inherited from my dad a mid 90's MF1235 tractor which runs fine with about 800 hours on it. He had a MF1216 backhoe attachment which sat for about 10 years and I...

Good Morning Everyone, I have to say this is a top notch forum and a wealth of knowledge for just about any tractor owner. I have a 95 Massey 1235 Compact with a hydrostatic Tranny and need to...

We own a 1996 Massey Ferguson 1235, Last year we had a Woods Front mount bucket loader installed at a local dealship. The hyd. lines to the loader attaches to 4 factory mounted quick couplings...

I have a MF 1235 3cyl. diesel iseki and it only has 10 lbs of oil pressure. My question is: What is the operating oil pressure supposed to be? I have changed the filter and put in a new gauge.

Can someone provide dimensional info on an MF1235? IE; length, width etc.

Where could I find a service manual for my MF 1235? I've looked all over the internet and I can find them for similar models (MF 1225, MF 1240, MF 1230, etc). Jensales has them for those...

The front drive shaft on my MF 1235 sheared off about an inch back from where it goes into the front axle. For the life of me, I can't figure out how to get the shaft out of the axle! There was a...

Does anyone know where I can purchase a MF 1235 Service or Repair Manual. Does the dealer have one and if so what is the part number?

The front axle started leaking on my MF 1235 where the right side wheel arm rotates(kingpin?) after I ran into a log in the yard. Don't know if I've done a good enough job of explaining where it...

My MF 1235 with 450 hours will not start without using the glow plugs and it just pours out black smoke when I try to start without the glow plugs. It runs well and does not smoke much at all once...

My MF 1235 with 450 hours will not start without using the glow plugs and it just pours out black smoke when I try to start without the glow plugs. It runs well and does not smoke much at all...

I'm looking at two MF tractors at two different dealers. Not a whole lot of difference on the surface, but hopefully you guys can shed some light on the differences and help me decide! 1. MF...

\'97 Massey Ferguson 1235 Price? Yesterday, we bought a '97 MF 1235 at a tractor auction. It has a 72" belly mower, 360 hours, and in great condition. I'm trying to find out how much this would...

I recently discovered a MF 1235 tractor that is 1 to 2 years old and has seen only a little over an hour of use. I understand the owner bought it at an auction and it is gathering dust in a...