Recent content by 2bits

  1. 2

    Help Identifying Idiot Light Not in my Manual

    Thank you all for your answers, suggested threads and advice. I removed the DPF can and cleaned it with compressed air. It took about 15 minutes to remove and about 1 hour to blow out. Luckily I am on a job at a friends farm and he has a very large compressor. Had zero flow through filter for...
  2. 2

    Help Identifying Idiot Light Not in my Manual

    Thanks Seville009. Found that last night and after reading up on the DPF and how it works I will be deleting it as my tractor will never run hard enough to keep it clean. In the interim I need to use it and it is unusable as long as the filter is in place(won't run). Can't run it hard to heat it...
  3. 2

    Help Identifying Idiot Light Not in my Manual

    Thanks Earplug. You confirmed my suspicion. Now the question is can it be cleaned in the field as it has clogged to the point of not wanting to run. Not sure it will even load on trailer. Tractor is mostly used for forklift purposes and never runs hard.
  4. 2

    Help Identifying Idiot Light Not in my Manual

    2017 3520R Can anyone Identify this light on my cluster? Tractor as had this for about 2 hours run time over a few days. Has now slowed and will die. This change took about 2-3 minutes. Will start and idle for a minute or two and then choke down and die. Is it telling me clogged DPF ? Does the...
  5. 2

    Need help identifying hydraulic fittings/hoses for powering backhoe.

    I spoke with Jared at Dave's Tractor today and he said they now do it different and it is even more simple. Take the Hydraulic hose that attaches at the top of the transmission and this hose is now your high pressure hose and the fitting it was attached to is your return line/port. Simply need...
  6. 2

    Need help identifying hydraulic fittings/hoses for powering backhoe.

    Ericm79: That is exactly what I saw on donor tractor. No hoses/connections going all the way to the PB at loader valve. Will use your description and call your suggested source. Thanks to all
  7. 2

    Need help identifying hydraulic fittings/hoses for powering backhoe.

    Above picture is of donor tractor factory hookup. Does not go through loader valve PB. All hookup is left side case under seat and the pictured fitting at rear of tractor near top link. Two short hoses, 2 adapters to case and ag couplers is all I need and I can mount backhoe. I need specs/part...
  8. 2

    Need help identifying hydraulic fittings/hoses for powering backhoe.

    lower fitting in picture is fitting I need. This is first backhoe hookup. Second fitting is about 2 feet forward of this and on left side of case.
  9. 2

    Need help identifying hydraulic fittings/hoses for powering backhoe.

    You are correct. The PB circuit will be utilized for a 3rd function at some point in future. The remote hydraulic at rear is what I am in need of now. It should be available at rear of tractor via one/two of my current plugged connection points. Again, this is based on my observations of the...
  10. 2

    Need help identifying hydraulic fittings/hoses for powering backhoe.

    There is a plug on the left hand side of case below rear lift hose. This may be pressure line. With return line further under tractor on left side. Here I also just hab a plug, no hose or fitting. These are the locations on the 3520 of the guy I got backhoe from. Our tractors are identical save...
  11. 2

    Need help identifying hydraulic fittings/hoses for powering backhoe.

    You are correct. No power beyond at rear of tractor.
  12. 2

    Need help identifying hydraulic fittings/hoses for powering backhoe.

    QC is simple 5675 AG couplers. It is the fittings/adapters that thread into the tractor that I cannot find sizes or part numbers for. And yes, the length for hose is easy to measure once the two are mated. But, if someone had the same setup and could let me know ahead of time it would be much...
  13. 2

    Need help identifying hydraulic fittings/hoses for powering backhoe.

    New to me 2019 Branson 3520r with 83hrs. New/unused and never mounted BH76 backhoe. I cannot find the 2 adapter fittings and hoses for powering the rear remote on the tractor. Saw the fittings/hoses on identical tractor of person I bought the backhoe from but cannot find part numbers for them...
Top