Recent content by 60lp

Just put a new power steering pump on and it squeals if youæ±*e turning the steering wheel I know I致e got a very slow leak in the steering column the fluid is coming from looks to be a weep hole in the column itç—´ self what could cause this I知 getting ready to rebuild it also any help will...

Anyone got pics of a 911 backhoe attachment adapted to a 773 bobcat with outside backhoe brackets ( mounts) I知 want to convert mine over to fit this machine any hep would be gladly appreciated thanks and have a great day

I知 inquiring about the the traction control panel my machine has around 1500 hour this panel gone bad the machine will not go forward or backwards or let the hand controls loader up or Down but rest of the panel is fine so what asking is they anyone offers a aftermarket control panel with...

Ok folks my 773G turbo the left side control panel is not all working I have no power to the operation switch but the traction lock button works all gauges work it move forward and back left to right but no loader controls at all I was if theyæ±*e anyway that somebody makes a aftermarket panel

Trying to find out what a ditch witch V30 flow GPM for the backhoe unit mine has 4 operation levers for the backhoe attachment and I知 wanting to convert over to a joystick systemI j

I'm trying to find out on my tractor if it's open center or closed center also what size is the hydraulic tee that goes in the hydraulic system for auxarilly remote I'm going to use a gresen 2 spool my serial number is T4R3C 162035T also how how can I post pics on this site any help would...

I'm trying to find electronic ignition for my Air Products model AP 200MG 6.OCCK-331E/5289L serial 0470209494 120 volt single phase 3.5KW @100% Duty Cycle 60 Cycle @ 1800 RPM I hope I give enough information all will be very appreciated also I'm needing a carburetor build kit also thanks again

Ok my machine is a non hi flow machine I'm in the process of building a brush hog made from 6ft medium duty 3-point Bushhog brand cutter so I'm looking at buying one of the ag 6 spline hydraulic motor also what else would hydraulic motor and what other hydraulic stuff to finish this thanks again...

My pedals are hard and sticking just wanting to know how hard of task of rebuilding the brake pedal valve and what Parts i need

I'm wanting to see if anyone has built a dozer blade for a john Deere 3-cylinder engine tractor if so I'd love to see some pics I've got a Meyer snow plow with power up and down also has cylinders for left and right for pivot back years ago my dad built a dozer blade on from a snow plow blade on...

Any pros or cons I'm wanting to build a muffler for my machine using a piece of 4" and some angle iron and 1/4 plate this will be made to almost like the factory any advice or pics would be gladly appreciated

OK here's the problem I'll be operating the machine then all the sudden all Bobcat interlock control system all lights go out and machine locks down no controls work shut the machine off let set few minutes back to work for five minutes and does it again please in bad need of help

I've got a 773G turbo I'm wanting to make a cab entry door since I've built a brush hog attachment just seeing any has made such also I'm wanting to build a skeleton bucket for my machine I'm taking a old 60" tooth bucket the bottom is worn out and have some 5/16 flat bar and heavy gauge tubing...

Since I've not found a used loader for my tractor I'm thinking of installing front mount blade like a snow plow that has the three cylinder one for up and down and the two on bottom that turns it from left to right any pros or cons on this like to see some pics of different styles that folks...

I'm in the process of building a muffler for my machine seeing if anyone has done this if so any pros or cons and like to see some pics