Recent content by 790greene

Ok. I was going to add a fuse as well. Just curious. Thanks for the information. I appreciate the help. 👍

Yeah, I'll have them mounted under my canopy so I won't have to worry about ripping them off. Did you have to add a fuse as well, or is that wire already fused? Thanks.

I recently purchased a Kioti ck4020. It is the manual transmission, non SE model. I'm looking to add lights to the Rops. I was told that there is a plug under the dash to add a switch to. I am not sure if that is correct for this model. The guy who told me that had the SE model. I was hoping...

Dealership kept giving me the runaround on when the backhoe was going to arrive. They never had any information when I called, after telling me they would keep me updated. If it was that hard to get them to take my money, I can't imagine how hard it would be to get service if needed.

Will do, thanks.

Well, the dealership didn't come through for me on the LS. So I signed papers yesterday for a Kioti ck4020 instead. 🤷🏻‍♂️

The tractor was there. Was just waiting for the backhoe, which should be delivered this week. I will ask them this week. I doubt I'll put hooks on it. I never used them on my Deere either. I try to avoid pulling anything with the bucket, out of fear of damaging a cylinder.

Yeah, I added a bar to my John Deere. Just would rather not drill my bucket until it's out of warranty in case something happens. I know how companies would not want to warranty it because it's been modified.

Awesome, I greatly appreciate it. I will have to ask my dealer if it's in stock. I would like to get it on before I use the bucket. I would hate to bend it or something before I got it reinforced. Thanks again.

Ok. I see most tooth bars and cutting edges have pre drilled holes, but wasn't sure if the hole spacing is universal or what. I am just looking to strengthen the bucket. I've read that they are kinda flimsy and easy to bend without reinforcement. Thanks again.

Ok great. Thanks. I greatly appreciate it. Bolts included as well?

Ok. That is how the tooth bar mounted to my John Deere. I was hoping to use the bottom holes to strengthen the bucket better. I have read the buckets are pretty flimsy nowadays. Thanks.

I was looking at those as well. Do you have the 66" bucket? If so, were you able to use the factory holes? I'd rather not have to drill my bucket. Thanks.

Do you have the 66" bucket? If so, any idea what the part number is? I'm looking for something to hopefully use factory holes. Thanks.

I'm getting a new 240E this week. Anything I should look out for? I am getting rid of my John Deere 790 finally. Also considering a toothbar, or cutting edge for the bucket. Any recommendations? Hopefully it serves me well.