Recent content by AFChief

Uhg! Halfway through the lawn and my BX2360 just dies. The engine is running fine when not under a load. Anytime I engage the PTO (mid, running the MMM) or try to move via the pedal, the engine bogs out. I checked the trans fluid and it's good. Moving the three point up and down doesn't...

Hello. I came in from clearing with a bush hog and ratchet rake. Pulled into the drive and turned the key off and the tractor kept running. I thought I could kill it by trying to move it while I wasn't seated, but the tractor would move. Pulled off the batt shroud and checked the back of the...

Hey gang! My Bx2360 throttle vibs back to idle while I'm mowing with the 60 inch MMM. I'm still under 50 hours so I'm mowing at about 2500rpm. Anyone else have this issue?:confused:

Please chime in. Finally found one of these for my BX. I went to put the lift arms together and have some questions. The photo on the site and the illustration in the parts book don't coincide. If you look at the attachments, the photo shows the two top link arms to the outside of the...

Well, part one of my carry all is complete. CA from TSC. It had some paint chips and scratches so first order was to address this. Figured since i was going to have to put paint down, i would do the whole thing. cleaned up the surface rust and scuffed up the yellow paint with 60 grit. Next...

Hello all. I've just ordered a BX2360 with FEL and a 60"MMM to be delivered next week. What do I need to be ready? I've bought a deisel can and just picked up a Carry-All from TSC. It will be planked and modified this weekend. Plan on putting her right in the warm shop and put on a coat...