Recent content by allengentry

I've welded many a set before and thought I'd pass along what I know. Preheat to 600*F with a soft flame. Postheat to 800-850*F with a soft flame. Cool slowly. NEVER weld on the face, or under any circumstance the INSIDE RADIUS of the HEEL. Normally, never weld within half the diameter of...

I bought one of the quick detach type overrun clutch/couplers from Hoye and have used it about 6 hours total with a Howse rotary cutter. There is now a TON of slop in the clutch assembly. As a result my pto shaft does not spin, it wobbles. I don't like this at all. Is this common? I have a...

Engine started and ran fine before tear down, now it won't start. Full fuel tank. New fuel filter, bowl, and o-ring fully saturated and primed. Primed at the injector pump. Cracked open hard lines and bled at the pump 3-5 times. Cracked open the lines at the injector and bled what seems...

Hey, First post here and I'm looking for some information. I bought a low hour (360) F13D to do some clearing and bushhogging in my trees. I wanted something 4wd, small, very manueverable, and I got just that with this tractor. Problem is, the head gasket started leaking, and I caught it...