Recent content by Andy JH

Think I might just cehck that there is oil in there from time to time. Thanks for the replies

No, this is why I am asking, the transmission oil level is a lot lower and when drained had no effect on the oil level in this compartment. Starting to think this might be the answer Possibly.

It is a solid plug, no vent hole. Internally you can see the selector shaft and oil. No filter. The transmission vent is located behind the seat.

Pretty sure all these little Chinese tractors are similar, even my old Kubota had the Transmission/ rear axel fill point located as per the photo. But what has me stumped is what this fill point is for. It opens into the housing for the High Low gear shifter so I was wondering if someone knew...

My neglected B7100 has spent the wet season (5 mths) under tarpaulin at the front of the property because I don't have a shed (barn) and now that the cyclone (hurricane) season is coming to a close I thought it was time to get the old girl fired up and cut some of the jungle back. Attach...

Reading the owners manual for the B7100D I noticed that above the Tire specifications was a set of figures for Treads. F 825mm (32-31/64") R 650-700mm (25-19/32", 27-9/16") Any idea what they are refering too? The Tire specs are: F 6-12 2Ply (20.5x8-10) R 8-16 4Ply (29x12-15) I have read all...

Bit of History, this Tractor has been badly neglected, I am trying to rebuild it as I go along but it would be nice to get the Slasher and FEL which are currently living half way down my drive. I read a thread here that described how to change the O ring seals on the 3PH piston, Did that and the...