Recent content by araz33

I have a 431 with a tach problem It works intermittently. Sometimes holds at 500 before jumping into operation. Sometimes holds at zero before engaging. At one time made loud screech until engaging Not wired to anything how does it get a signal-from where

Im thinking of buying a Westendorf quick attach for my Massey 1040 FEL Anybody have experience with them or any recommends for quick attach system

I am trying to decide on a new rotary cutter. I have narrowed it down to the 8' HD Mahindra and the 8' AG Modern Predator. I have a Massey 431 and would like to use a pull behind type. I'm using a 6' cutter now but I have always wanted to widen the footprint. My limitation is the 46HP PTO. In...

I own a 431 that came with the property I purchased. Recently I lost one of the stabilizers. They seem available on e-bay but I am not sure if they were different part numbers for each model. I have not been able to find a parts list. While looking over the parts I noticed that check chains...

My goal is to add remotes to a 431 so that I can use a 6ft Taylor Way offset. Massey parts not available close by and I would like to do this myself if possible. Question: Operator's Manual states- "a single section hyd control valve can be fitted to this tractor." Control valve and lever...

I have a broken right stabilizer on my tractor. The pin that goes into the lift arm snapped. The pin is cheap enough but the replacement bolts and nuts are expensive and can only be ordered in large quantities. In your opinion which dealer should I go to that has a large inventory of parts. Is...

Just acquired a 431 that was a bit neglected. Brakes were almost bottomed out the first time I used it. Tried to adjust but the star adjustment is frozen. Any ideas on how to break free without removing the tires and breaking it free. Should I just try and adjust with the turnbuckles and forget...

Just purchased a new place, bought with a MF431. Sold my Ford 4600 thinking I would never need it again. Now I need to turn the sandy loam over to sprig with grass. It looks and feels like it is compacted. Flat as can be since once used as a grass farm. Two questions: I have read it is rated...

BX2660 came with the home I just bought. They didn't leave manual. Question: rear deck won't go down- mowed with it this morning no problem. Tractor in 'n'- set throttle..-handle set on picture showing rear deck set up- push down on handle to lower deck no response. If I move handle against...

Need to male a decision- I own 20 acres just west of Houston. House site 1 acre remainder in Jigs. Five acres in front of my house is in jigs and has oaks that are hard to get around in my Ford and shredder. My wife would like to help out around the trees and cut the yard keep the shoulders of...

Ready to buy a ZTR and I have decided that there must be a better approach to purchase decision process than comparing specs. Please allow me to ask for you opinion on the following question. With the proximity of the service available ranking first and price being the final consideration-...