Never mind, I figured out what I had not done. The Drag Link needs to be installed to pull the units the rest of the way. No gap now and everything is turning smoothly.
Hi, I was hoping someone could help with this issue. I had to tear down the right hand 4x4 hub to replace some sheared off bolts for the drag link. I have both the service manual and an exploded diagram I acquired from the New England Tractor web site. I know I reassembled everything...
Help please. Has anybody been able to find just the fan motor for the pro turn 460? If not any aftermarket assemblies which would work? I am trying to avoid paying 482 for the whole assembly. Also a suggestion as to a supplier cheaper than 482 would be greatly appreciated. Thank you.
When using the FEL to push dirt, grubbing etc. while going forward the tractor is fine. When I back fill without putting much strain on the tractor it will immediately lug and shut down. This happens so quickly you do not have time to depress the clutch. This did not use to be a problem. Fluid...
I think the 4wd part broke today. The only check I could think of to verify this was to have it in 4wd and lift the front wheels up off of the ground with the fel and see if they would spin freely. I would think if the 4wd was engaged the front wheels would not spin.
could someone verify or...
MF 2745 V8 diesel, cab, double tires on rear
An associate of mine has a decision to make about his MF 2745. The tractor needs a complete engine overhaul / repair and he has been quoted $6,000 to $8,000 for the overhaul.
The question would be... is it worth it ??? or scrap the tractor. Would...
Help
Bought new in 2001 / I now have about 800 hours on it.
My 4110 tractor has started to overheat. I have not let it boil over yet and quit using it when the temp reached 200. If I start mowing it takes about 2 1/2 hours before the temp reaches 200 degrees. The overheating only occurs...
Have read many of the threads and would like someone to double check my conclusions if possible. I need to go to an after market oil and hydro filter since my dealer closed up shop shortly after I purchased the tractor.
From comments on the board it would appear my 4110 can use the following...