Recent content by arlen4720

I just replaced the original battery in my JD 320D skid loader…It is a 2010!

What do you figure the cost will be “all in”?

Don’t see too many backhoes or loaders on articulated 4wd machines

I split my b a couple years back for a total engine rebuild. You can have them split pretty fast. One thing regarding ring gears… I was putting a new clutch in also, and resurfacing the flywheel, so I figured I would put a new ring gear on. So I ordered a new one from Steiner, and dropped it...

They still have the complete replacement engines on JD Parts. I just looked it up and they are available at the factory for the dealer to order. 10,000 and some change. I would lean toward a new engine, but total cost would be higher since there would still be quite a bit of labor to install...

I don’t plan on changing my bolts

yes, standard righty tighty. They are tight…IIRC they are torqued to 625 ft lbs. Here is the manual, they have the whole procedure in there. I need to replace mine soon.

I jus use a needle greaser on those u joints on my x748

In your case, it sounds like the alternator is at fault for both the ERR_4 and not charging the battery. I would remove and take to a local automotive electric shop to have it tested and rebuilt. If your machine is an open station, the TCU computer is located in that panel below the steering wheel.

Did the needle go into the red, or was it 3/4 of the way into the green?

I can’t recall exactly what temp they run at. I believe it is in the 180-190ish range. I don’t really think it is a gauge “issue”. They just all run 3/4 of the way over. That is normal. I’m attaching an excerpt from the service manual. It is a list of registers for the 3 on board computers...

3/4 over is where they all run.

it is invalid or incomplete engine speed data on CAN bus. Do you have a service manual? There are a couple things to check. I can copy some pages for you tomorrow if you want. My service manual is for my 4720, but those parts should be pretty identical. What year is yours? Just wondering if...

I just put a set of camso 532 on my skid loader a couple weeks ago. Bauer Built says they sell many of them, and that’s what they recommend. Too early to tell how good they are, but if they are crappy, I doubt Bauer Built would be staking their reputation on them.

There is a filter on the pressure side of the power steering system. It is in your manual. It’s right along the frame on the left side. When that is plugged, it will cause this issue.