Recent content by ArXane

CK3510H - 300hrs - Blowing Horn/Blinker fuse - So a couple weeks ago I did a quick tap of the horn to get somebody's attention, horn made s split second sound and nothing. Investigating I found the fuse blown. Fuses dont blow for no reason at all, but couldnt find any issue. Put in a new fuse...

Here is what I did on my Kioti. I power cable from the battery to two relays. The relays then feed a marine grade switch panel. I have two LEDs mounted on the ROPS pointed forward, one mounted rear and one on a swivel kind of behind seat that I point at the PTO.

Im going to start on a project to to add some lights for a worklight and the ROPS. For the worklight behind the seat that I point at the PTO, I use the connectors for the bullet connector. Im/was going to use a relay for three LED lights that will go on the ROPS, I see that there is also a...

I got a skidding winch a while back, and can now see the benefit of a self-release snatch block. I'm going to have a sheave made, but the directions I have on to make one only has a 1/2" difference between the rims. Can I get somebody to measure the outside diameter of each rim on your sheave...

I have a Brush Hog 305 that I am goign to try and get going. Its been sitting for about 8 years under a tree. On inspection I cant decide if a nut is missing or not that holds on the stumpjumper? When I first looked at it they had wedgets sandwiched between the pan and the deck to keep it form...

I got this little project complete. Very happy with it, I purchased the receiver and used some 1" scrap. Maybe would work well for others with a ripper that have a removable shank.

Does anyone have a copy of this manual? Im specifically looking for fluid capacity's and recommendations. Also looking if there is a way to tension the chain and to adjust the slip clutch. Thanks!

I have a heavy duty single shank subsoiler/ripper that has a removable shank. Im thinking of removing the shank when not needed, and on the top of a reciever, weld up the same thickness of steel as the shank and bolt it in, thus giving me a way to have a 3 point receiver. This should work...

I want to to have a hose made that fits into my rear Hydraulics. Im still not quite sure on what size fitting goes in here? Its a new Kioti. In the manual it says to use:"PT 1/2 Coupler Socket - Hose unions must comply with ISO Standards. Dimension must be between 0.806 and 0.809." I called the...

I was given this 100gal fuel tank below. It came with an electric pump. Was used for who knows how many years in construction for refilling generators. They got rid of it because they went to the type that goes underneath a toolbox. First thing I did when I got it was drain it as it had about 15...

I have read and re-read the manual for my CK3510H and am still a little confused. When do you use the clutch aside from PTO/Starting. I am currently using it to change speed ranges (H/M/L) and thats about it. Should I use it to engage 4wd? I have been changing to 4wd while in motion and it seem...

I want to order two 12" +/- hydraulic hoses online with male quick attach on each side. Anybody know where to get pre-made hoses like that? My Google Fu isn't working for this.

We have had an antenna build for about 3 years in our coop. I made a slot that the door drops down into to keep coons or anything else from getting there claws under it to push up. Never have had an issue with anything getting in. I can get a pic of the lower door part if you want. Link to coop...

Correct, with nothing attached. I was thinking about just putting some tbolts in the lever slots with some blue locktite, still seems like there should be a better way.