Recent content by Austinopa

Thanks for the reply, I have attached better pictures of the input shaft. (The cuts on the edge are from cutting the spacer off the stump jumper) Only way I can see to pry cover off would be to drill a hole in it and put a screw in it??

Hi I bought an older 5' shredder and it shook a bit but I thought the blades might be out of balance, but later found the stump jumper had been bent about 1/4-1/2". So was wobbling. After finally getting it off I had damaged the oil seal on the bottom. So started disassembling it, to replace the...