Avenger's latest activity

I hope LouNY and others try to make Eurohooks usable from the tractor cabin. Here is JD and we can move the lower arm with that link on...

I modified my grill. Here is the video. I absolutely love it and should come factory this way.

2018 Boomer 40 here made by LS. I'm one of the turbo failures at less than 100 hours. Manual stated 10W30 CK4 year round. Service...

You should never need a hammer to pin or release the quick connects. If you do find the problem and fix it long before you break the...

Dunno if it would fit or not, but the levers on my MT240 are a single piece with bends, no welds. I took them off, adjusted and lubed...

Mine have gotten stuck a few times. And when they were stuck, they were STUCK! It took a hammer to move them. Fortunately, they did not...

Normally I was opening and closing them by hand. Every once in a while I would have to stomp on them to go into place but that only...

Usually when mine wont slip right in a ply bar will move the attachment side to side a 1/4 inch to line up the holes. Keep your QA...

Here is the video I watched a while ago. I one above is a complete, made to order, SSQA attachment that will replace your existing SSQA...

508 hours and still pretty decent. I blow out the outer one regularly from inside out. Replaced with same Donaldson P822768 & P822769...

For a replacement OEM part or similar, unfortnatly no. I don't know of any. But I was considering doing something similar to this on my...

As a 4 year old and again as a 10 year old spending summer on grandparents farm the buddy seat on the fender was highly sought after…

Talk about resurrecting an old thread! For me, my young son is now 5! And is a bit too big to ride with me in the cab. Short of making...

Do you have this switch?

Wow... I have questions. You're coming into a bale with a spear on the FEL. You push in the clutch, the tractor goes into neutral, then...