Recent content by Avenger

@Budlight592 PM sent

There are two ways that I know of. One is to disconnect the battery for a few minutes. That should reset any codes. However, I have not tested that method. The second way, and the way I've done it, is to get the ELM327 OBD2 reader from Amazon. Link It's cheap, like less than $14 This reader...

PM Sent

I wish I had a concrete floor to put all the implements on. I'd make those little dollys for everything! Growing up we had the "pad." It was an old shop or storage shed, without the shed. But did have two opposing 4ft (or so) concrete walls with dirt berms, the other two sides were open, and a...

PM Sent

I look at the tread where it meets the ground. If it looks cupped, like the tire is only touching in the middle, its too much (not exceeding the sidewall pressure if listed, mine is not). If the sidewall on the ground looks squished, and the tread is in full contact, its not enough air. A good...

Another, very common issue with these tractors is the chassis ground connection. I know the OP mentioned that everything comes on when the key is turned, but wont crank, and that might sound like a good gound. But it has been my experience (and many others) that the ground connection is not good...

Are you referring to the 7-pin connector on the back that is under a little door cover? If so, thats for hooking up lights to implements and whatnot.

I currently have a small leak from the axel. I noticed it after about a year or so of ownership. I took it into the dealer for warranty repair. A few days later they called me to complain about the severity of the leak, that it wasn't bad enough. A few weeks later, the dealership called me to...

The cruise control shouldn't have any effect on starting operations, but turn it off anyway. Did you try to jump the key switch? Can you turn the tractor off from the the key? Typically, when a vehicle wont start by the key switch, but will by jumping the starting solenoid, the problem is with...

Our winter was a complete joke this year. One good snow storm that dropped a few inches, then warmed up. Plenty of rain, but very warm winter. Not surprised you're able to get out so early. Make hay while the sun is shining... or something.

Are you getting any codes?

The regeneration cycle is designed to burn out the soot and particles captured in the DPF. To do this, the engine must get hot and then start the cycle, which burns more fuel to increase the exhaust gas temperatures. It makes reasonable sense to run the engine hard, preferably under a load, to...

Interesting! Good catch! Is this the bearing under the steering arm on the king pin? I don't think my tractor has a bearing on the tie-rod ends, just pins. I looked at the parts catalog for your tractor (and mine, which are pretty much identical) and I didn't see that bearing in the diagrams...

There is much that I have learned from this thread and from my own research. For example, it never dawned on me that burring a kerosene or diesel heater would be the cause of so much condensation. After doing some pondering and discussing the issue with SWMBO, we have decided to go in an...