Recent content by AzChopp3r

My new tractor has a cab. LX3310. absolutely love it and I had the same concerns as you. Get the cab

Something happened today that has me worried. I had unloaded the tractor and was about a mile down a dirt road clipping along probably around 12 mph when the tractor suddenly locked up and skidded to an immediate stop. It was so abrupt that I thought i ran into a stump or something and there was...

I have a JD 4300 and I am thinking with the season approaching, it would be a good project to build/weld up a new log splitter and make it 3pt. Pressure: 2500 psi [172.4 bar] Valves: 2 Pump flow: 8.3 gpm [31.4 lpm] Total flow: 13.3 gpm [50.3 lpm] There is the hydraulic flow for the pump on...

Hi folks, where is a good place to get a valve kit to run a grapple on the front of my JD 4300? Basically want to tie into rear hyd outlet with quick connect, run hoses to elect. valve which is operated by a switch on the stick, then run hoses to front of tractor and end with quick connect.

Recently I had to dig into my MFWD on my JD4300 a bit in order to replace a leaky spindle seal. Talked about it here a bit. I thought I would snap some pictures and share it with you. Mind you I am not a certified mechanic and I am sure that I probably did some things the hard way but the...

Hi folks, sorry to revive such an old thread but I have a leaky seal on my 4300 I posted about it here :http://www.tractorbynet.com/forums/parts-repairs/310404-jd-4300-mfwd-seal.html without any response so far probably because it is in the wrong area. I am in the process or researching this...

Hi folks, anybody have one of these apart? Looks like a leaky seal and who knows, maybe a worn bearing causing the seal to fail.

Or it should say Im going to rebuild them as soon as I figure out how to take them apart. :) Since my last post here: http://www.tractorbynet.com/forums/hydraulics/288209-air-hydraulics.html I decided to go ahead an order the seal kits for the bucket cylinders for the 420 loader on my 4300...

Hi folks, I have a John Deere 4300 with a 420 loader that I acquired a few months ago. I noticed something goin on with the loader for a few weeks now. With the loader raised off the ground and bucket level, I can stand in front of the bucket and grab the cutting edge and lift the bucket and...