I have a tg-48-xb tiller king kutter putting it on Kubota 2660 trying to size shaft when in longest position I ownly have 9 inches between each ujoint sheild if I cut 3 inches off each end I wont have a 6 inch overlap any suggestions?
Some how a small piece of wood got by the little plastic cover where the drive shaft enters the front end in my bx2660 the seal is now leaking . had to add oil. question ? how hard is it to replace the seal ? is there a diagram of this area?
New member here from southern Illinois Look forward to getting more info on the threads Normally spend winters in South Texas but with a new tractor etc. I am waiting here for snow. Cold here but no snow so maybe it wasn't such a good choice.