Recent content by BEB101B

Thanks for your reply !! Altogether these replies helped us to find and remove blockage between fuel tank and fuel filter (hope it doesn’t come back!)

Thank you for your reply - there was indeed a blockage between tank and fuel filter!! Thank you for encouragement to find & remove the blockage - it worked!

Thank you so much for your reply. The fuel was just drip drip dripping at the filter air bleed screw, before we blew air through the line from fuel filter back to tank (had to take floor board off to do this). That must have cleared a plug (hope it doesn’t come back) in the fuel line from tank...

On my GC1710, (1500 hrs) when it’s running, rpm’s then die off like it’s not getting fuel. Then sometimes it runs just fine for a hour…Drained some water from fuel filter and replaced filter, but having same problem. Put diesel treatment in fuel tank- no change. Am wanting to bleed air from...

Now, after taking off deck, taking off the anti spin bracket and bushing (#20 on parts list) and found it to be heavily scored and the bushing it fits into on the clutch to be ”wallowed out” a lot! So just tugging on the bracket doesn’t really tell the story and Randy T’s diagnosis identified...

Thank you for your reply, Randy T! Checked the anti spin bracket this eve and found it to be solidly in place and well connected. Didn’t know about it until your post, so hadn’t checked it before, but it appears to be solidly attached. If you have any other ideas, would appreciate hearing...

The wires that runs from the mower blade-engage pull knob to the electric clutch have torn loose from the plug at the electric clutch 3 times now. Don’t know why this keeps happening but we replaced the drive belt last fall. Apparently some rotating machinery is catching the wire even though we...

We have a New Holland 202 Manure Spreader which was inherited. We can get the "throwers," flails and shreaders to work, but when we work the table drive lever, nothing seems to engage to drive it to work. The lever does not seem to make anything go onto the ratchet wheel, which is on the axle...