beenthere's latest activity

Same problem as last week? https://www.tractorbynet.com/forums/threads/yellow-110tlb-rock-arms-inop.441931/

Maybe will need to locate different rims to fit the R4 tires.

Update. It was a bad connection in the seat safety. I cleaned the connection and it started right up! Thanks for the help all

Found a lot of slop in the PTO engaging lever, and need to find out where the slop is located. Appears to be at roll pin #12, but may be...

I have a PDF of the tech manual, if wanted message me your email and it's on the way- from the manual -

looks like it starts at the engine pulley right side of belt goes behind V idler, and then back in front of flat idler, around...

Found it https://partscatalog.deere.com/jdrc/sidebyside/equipment/74954/referrer/search/pgId/114685405/partnumber/LVA15436/callout/12

Suspect bad battery or cable connections.

Suspect battery first. Get it load tested and may need a new one. Second, while load checking the battery, clean all pos and neg cable...

If I understand your question or confusion, it is one of the three spindles/hubs/pulleys. Link again...

That helps.. was going to ask after the first post, but waited to see if this would get filtered out. Figured any mistake would be seen...

Do what feels good to you. Either way, won't make a tinkers damn of difference that is detectable. Nothing to debate. Books had to have...

Don't believe a word of it.

I sold my 2305 nine years ago, so I am going strictly on memory. So don't set me on fire if I'm wrong... The 2305 never had a drive-over...

Probably friction washers need tightening.. (adjustment).