beenthere's latest activity

Spinning under power? i.e. If the mower (or other PTO attachment) is already connected, will the PTO stop spinning if the clutch is...

Being a 2 stage clutch, are you pushing the pedal all the way down before engaging the PTO? The PTO clutch is all the way down; the...

Hand crank assembly from jd parts, and hope you are zeroing in on the right solution...

Before retirement I was an engineer on this product. The Select Series premium spec'd decks have 20mm spindles with open bearings (NTN...

Fuddyduddy1952 I'm thinking this '50's model 40 doesn't have a clutch fan and new parts are not available. Finding a new nut to fit the...

A long ways away, but some on craigslist up Wisconsin way. $700 - $1000...

Welcome to TBN You might try some other fluids to see if they will work, but is it really worth it if they don't work the best ? Deere...

Is yours a dual clutch ?

Maybe it is the 4052R ?

Yes, laying across the mower gauge wheel to get one hand on that slip connector is a stretch, for sure. At least it doesn't require two...

A trick to disconnect the PTO slip connector on the non-AWS 425 is to reach it from the rear underneath the transaxle. Doesn't work on...

Not that I know of, assuming you are speaking of the universal joints on that PTO shaft.

Maybe easier to remove that fan bracket (key#4) that the nut is attached to for better leverage (heat ? ). Suspect that large nut is...

Can you post a photo or two of the area ? Been awhile since seeing the two-cyl 420 but have a faint memory of changing the fan belt...

I've seen duals used to reduce compaction many times. Been times I've wished they would work with the pull type forage chopper.