Recent content by Big Joe

  1. B

    Craftsman saw runs short time and quits

    My Craftsman (Poulan I'm sure) saw runs for about a minute and then quits. It will not start for quite some time afterwards and then quits again. Help!
  2. B

    Cleaning Greasy Zerks and Pivot Points

    I mow in a pretty dusty environment and have a heavy accumulation of dirt and grease around the grease zerks and pivot points of the FEL on my Kubota. I clean the zerks with a rag the best I can before greasing, but some of them are pretty tough to get to. Should I use some sort of degreaser...
  3. B

    Poulan PRO 8 in. 31cc Gas Pole Saw

    I need a gas pole saw and was wondering if this saw from TSC is any good. It's cheap enough ($199), but will it hold up under normal use? Any recommendations? Thanks!
  4. B

    Northern Tool Log Splitters

    Looking for your comments (good or bad) on Northern Tools log splitters. I'm considering their 37-ton unit. Any other recommendations would be appreciated. I'm trying to keep my cost to $1,800 or less. Thank you.
Top